Beskrivning
Pull switch for lamps that you switch on and off by pulling a cord. Each pull changes the switch between on and off. Screw terminals for the lamp cable. Connect the incoming cable that the switch should break, and the outgoing cable to the lamp. The switch is screwed into the lamp through two eyelets.
The pull switch is 26 mm long and 13 mm high. The black part is 13 mm wide, 30 mm wide with the fixing. The distance between the fixing holes is 25 mm. The holes are slightly oval and about 5 mm, so the distance between the fixing points on the lamp can be about 20 to 28 mm.
This switch is for low loads. Max load is 2A, which at 230V means 460W.
You get one switch and one pull cord. You can of course use another cord if you prefer.
The pull switch is 26 mm long and 13 mm high. The black part is 13 mm wide, 30 mm wide with the fixing. The distance between the fixing holes is 25 mm. The holes are slightly oval and about 5 mm, so the distance between the fixing points on the lamp can be about 20 to 28 mm.
This switch is for low loads. Max load is 2A, which at 230V means 460W.
You get one switch and one pull cord. You can of course use another cord if you prefer.
Specifikationer
Mått
| Längd (mm) | 26 |
| Bredd (mm) | 13 |
| Höjd (mm) | 13 |
Tryggt att handla hos pålyset.se
pålyset.se drivs av Jolix AB och har sålt ljuskällor och belysning på nätet sedan 2011. Alla beställningar packas och skickas från vårt eget lager på Stationsgatan 10 i Boden.
- Skickas i regel vardagen efter att du beställt
- Leverans med PostNord eller DHL, 3–5 arbetsdagar
- Frakt 59 kr – fri frakt när varuvärdet överstiger 1 000 kr
- 14 dagars returrätt
- Handla över disk och betala på plats i lagerbutiken i Boden, fredagar 11–14
- Frågor? Mejla kundtjanst@palyset.se
